There are so many things that homeowners and builders alike would want to know when they are trying to integrate structural or decorative iron beam straps with the use of timber and one of which is how they can possibly search for the finest wood connector iron faceplate size. If you are going to have a new construction project, take note that you will need the service of an engineer or even an architect since they are the ones capable of specifying all the requirements needed for your application, which may include width, minimum thickness and also, size for the iron faceplates. That is not it at all as there are more that you need to know about the importance of architects and engineers like how they are necessary for determining both the diameter and the length of the fasteners (either the bolts of the lags) that are used in attaching the wood construction tie, which plays an important role in identifying the structural value of the post beam connection. The difference between bolts and lags as fasteners is that bolts can be rated as a structural grade eight as it can be bolted in through the beam using a nut on the other end while the lag only has a pull out value, which means that it can only be rated as a grade five in structural integrity.
When it comes to matter concerning the selection of the right wood connector iron faceplate size that you can use for your existing beam structure as you want to add additional support to it, one of the most important factors that we want you to consider is to always remember that you are simulating a structural support beam. With regards to this matter at hand, it would be best for you to select a wood connector iron faceplate size that is large enough so that your structural beam support will come out as something that really has a great value to it. In our research, we have found out that the finest way of choosing a size for wood connector iron faceplate is to cut a template out of a paper or a cardboard and then tape it or staple it or even tack it to your beam. It would be best for you to start with two inches wide and eight inches tall or long.
There are other ways on how you can get the best size for your wood connector iron faceplate like using a black poster board or you can opt to paint the template you have with black as this way, you can visualize it much better, and you must not worry about its design since what matters most is the basic size.